光电工程师社区

标题: fs,ps,ns在金属材料精密微结构加工中那个最好 [打印本页]

作者: zhangzw123 时间: 2006-8-31 23:32
标题: fs,ps,ns在金属材料精密微结构加工中那个最好
希望大家能够从不同的方面谈谈

作者: zhnzhn 时间: 2006-9-4 19:55

fs is the best one

because it is non-thermal processing and high removal rate

作者: zhangzw123 时间: 2006-9-4 23:38

i don't think so

fs is non-thermal processing but its removal rateis lower than ps,ns's, becauseitsREP RATE andpulse energy.

ps is non-thermalprocessing,its removal rate is higher than fs because rep rate and pulse energy,butits removal rate is lowerthan ns

ns is thermal processing,its accuracy is the worst but its removal rate is the best

作者: marchon 时间: 2006-9-11 01:13
这个不能一概而论，需要多角度考虑，比如多大的孔，多深等因素，更不用说价格因素了

欢迎光临光电工程师社区 (http://bbs.oecr.com/)