光电工程师社区

标题: Nd: YAG laser rods [打印本页]

作者: Raytress    时间: 2007-5-29 23:09
标题: Nd: YAG laser rods
转发. 谢谢报价. 请用EMAIL.
SPECIFICATION

Nd-YAG Laser Rods (Diffraction limited grade)

•        Nd-Concentration                : 0.7% atomic concentration of Nd3+ ions
•        Orientation                : [111] crystalline direction (+/-5 deg)
•        Extinction ratio                : 25dB between crossed polarizer in collimated He-Ne laser                                    beam
•        Wave front distortion        : <0.1 wave/inch of rod length @ 633nm (for a plane wave                                           passing twice through the crystal)
•        Scattering loss                :  Not more than 0.2% cm-1
•        Crystal Perfection                : Free of impurities visible to the naked eye.
                                  Free of Bubbles, inclusion, scattering sites as viewed in white                                   focused illuminator light under crossed polarizes.
•        End surface finish
#        Flatness                : 0.1 wave @ 632.8nm
#        Scratch & dig        : 20 – 10
•        Barrel finish                : Ground 55(±10) micro inch
•        End face configuration        : Flat/Flat, Cut parallel to each other with in 10 arc sec.
•        Chamfer                        : 0.005(±0.003) inch depth, 450(±50) Angle.
•        End coating                : Hard damage resistant AR Coating with <0.25% reflectivity at                                  1.064 mm wavelength.
•        Coating damage threshold: Not less than 1GW/cm2 for 10nsec pulse

•        ROD DIMENSIONS and QUANTITY:

     TYPE-1:  f 6.3 mm (±0.5) x 76 mm (± 1.0) (Length)

                                                                Quantity: 3 nos.
                                           
    TYPE-2:  f 4 mm (±0.5) x 76 mm (± 1.0) (Length)
         
                                                                Quantity: 2 nos.
作者: netfish    时间: 2007-6-2 23:13
呵呵,这个家伙到处询价的,楼主以后不要理小印度了




欢迎光临 光电工程师社区 (http://bbs.oecr.com/) Powered by Discuz! X3.2