光电工程师社区

标题: ASAP问题 [打印本页]

作者: guoxuemiao 时间: 2008-2-28 11:09
标题: ASAP问题

这是一个简单方形的管子,但是运行之后怎么会出现光线呢?(见最后一图,管子边框为光线)
我明明没有定义光线的.请大家帮我指出错误.

附件为图形

SYSTEM NEW
RESET
UNITS MM
MEDIA
1.52 'PLASTIC'
FRESNEL AVE    !! Calculate Fresnel reflections,
                              !! averaging the flux of the two
                              !! polarization states.
HLONG=30/2
HWIDE=0.5/2
HTHICK=0.5/2
GAP=0.001

SURFACE
PLANE X (HTHICK) RECTANGLE (HWIDE) (HLONG)
OBJECT '1'
INTERFACE COATING BARE AIR PLASTIC
SURFACE
PLANE X (-HTHICK) RECTANGLE (HWIDE) (HLONG)
OBJECT '2'
INTERFACE COATING BARE AIR PLASTIC
SURFACE
PLANE Z (-HLONG) RECTANGLE (HTHICK) (HWIDE)
OBJECT '3'
INTERFACE COATING BARE AIR PLASTIC
SURFACE
PLANE Z (HLONG) RECTANGLE (HTHICK) (HWIDE)
OBJECT '4'
INTERFACE COATING BARE AIR PLASTIC
SURFACE
PLANE Y (-HWIDE) RECTANGLE (HLONG) (HTHICK)
OBJECT '5'
INTERFACE COATING BARE AIR PLASTIC
SURFACE
PLANE Y (HWIDE) RECTANGLE (HLONG) (HTHICK)
OBJECT '6'
INTERFACE COATING BARE AIR PLASTIC


RETURN
PLOT FACET 5 5
WINDOW X Y
OBLIQUE
PLOT LOCALS OVERLAY ' the light pipe'

[ 本帖最后由 guoxuemiao 于 2008-2-28 11:15 编辑 ]

作者: dajuzhan 时间: 2008-2-29 16:45

PLOT LOCALS OVERLAY ' the light pipe' ------- 是POLT LOCALS 生成一个框图 . he he

作者: guoxuemiao 时间: 2008-3-11 16:29

PLOT LOCALS OVERLAY ' the light pipe' ------- 是POLT LOCALS 生成一个框图,
还是不明白.

作者: hemet 时间: 2008-9-8 13:18

如果不执行PLOT LOCALS OVERLAY ' the light pipe'这个语句
那么3D里只有6个面
执行PLOT LOCALS OVERLAY ' the light pipe'这个语句后
在3D里除 6个面外增加了一项RAYS,SPOTS,LINE PLOTS,et cetera
但是这项不是光源，只是plot locals命令产生的线框

欢迎光临光电工程师社区 (http://bbs.oecr.com/)