| Cabinet | Driver and power supply in single cabinet |
| Test Feature | Built-in test feature allows testing for max transmission of Pockel Cell without adjusting bias voltage |
| Input Impedance | Choice of amplifier input impedance by rear panel switch (50ohm/1K ohm) |
| DC Bias | Improved DC biasing of Pockel Cell provides greater linearity at higher bias voltages |
| Voltage Range | +/- 450VDC controlled by ten-turn front panel pot. Digital meter monitors differential bias applied to E.O. Modulator |
| Linearity | 10bits referenced to full scale (.1%) |
| Bandwidth | DC to >200Khz with 90pf load and 3M (RG-62) cables |
| Max. Output Drive Level | 750VP-P into 90pf load |
| Amplifier Input Signal | 2VP-P max into 50/1K ohms delivers 750VP-P out |
| Input Signal Format | Options include Unipolar positive, negative or bipolar |
| Input Power (AC) | 60W typical. Input power is both load (modulator) and frequency dependent. |
| Dimensions | 19” Rack Mountable, 5.25”H(133mm) (3U) x 14”D (356mm) |
| Cooling | Forced air |
| Operating Environment | Designed for laboratory use (indoor only) Temperature range +5deg C to +50deg C ambient Humidity 20%-80% RH up to 32deg C Altitude <3000M |
| Weight | 20lbs (9.07kg) |