illumination quesition

victorrose · 发表于 2005-12-5 06:13:00

When I proceed illumination analysis from menu “analysis => Illumination”. I can get results if I use “Aim box for raytrace”. 
On the contrary, can’t get results if I use “Aim into whole sphere”. 
Error message are as follows: 
Warning: Discarding current results. 
Warning: No rays intercepted the receiver. 
Warning: Minimum value = 0.00 Maximum value = 0.00 
 Contour plot will not be drawn

========================================================== 
Aim box for raytrace 
========================================================== 
NRA 100000 
CLR YES 
REV NO 
AIM 0.907 0.907 0 0 0 
PLO NO 
CON NO 
DIS YES 
RCV 2.563 1.922 0 0 
RCG 21 21 
SYM ROT 
SRC E1 0 0 0 0 0 0;RMX E1 1;SHA REC E1 628.2 471.1;RAP UNI E1 ;ANG E1 SUR;ANP LAM E1 ; 
GO 
========================================================== 
Aim into whole sphere 
========================================================== 
NRA 100000 
CLR YES 
REV NO 
AIM SPH 
PLO NO 
CON NO 
DIS YES 
RCV 2.563 1.922 0 0 
RCG 21 21 
SYM ROT 
SRC E1 0 0 0 0 0 0;RMX E1 1;SHA REC E1 628.2 471.1;RAP UNI E1 ;ANG E1 SUR;ANP LAM E1 ; 
GO

[此贴子已经被作者于2005-12-4 23:23:57编辑过]

illumination quesition

发表回复

浏览过的版块


热搜: 防雾膜棒料红外反射膜光电二极管镀膜机反射膜光谱仪光电探头真空镀银滤光片光器件应用光学 zemax激光远心镜头 sio2 增透膜离子源栅网 zemax 论文高反膜半反半透膜