有沒有人學lucidshape1.2或1.3的我有操作手冊可惜沒軟體 要的請留e-mail或提供ftp我會上傳的共計2本

lucidshape 1.91分亨，小弟不會用，看那位高手有興赵跟我联系qq:1979249222

求助各位老师 在zemax中或者tracepro中，建个模 鲍威尔棱镜 要如何做啊？ 谢谢

rt

各位大姐大哥，大叔大妈，谁谁设计灯罩啊 要求灯罩反射后，能均匀的照射在挡板上，灯罩距离挡板600mm，灯罩宽度102mm，挡板宽度500mm

A useful ASAP® command for simulating systems where the wavefront is needed is the OPDMAP command. This command is used with a geometric ray trace, and it uses the optical path length of each ray on a surface to determine the shape of the wavefront. This is a traditional technique used in most ...

When doing stray light analysis, it is vital to identify all objects that are seen from the detector. Dr. Bob Breault calls these "critical objects". These objects are important, because 100% of the stray light comes from them. If you can't see an object (either directly, or reflected in a mirror) t ...

Tip #8: Simplifying Material/Surface Property Assignments to Imported CAD Geometry If you are importing a lot of your geometry from outside CAD programs into ASAP®, instead of using the IGES or GTX translator to do material assignments in the geometry INR file, you can use a $DO loop in an ASA ...

Using the AXIS and EXTREMES POSITION commands in ASAP®, one can easily find the minimum and maximum radial coordinates of rays on a given surface. This is particularly useful when you have a non-rotationally symmetric distribution of rays on a surface and would like to find the radial position ...