CTI动磁光电反馈高速扫描振镜

 火...
4.7k 6
发表于 2010-4-26 16:12:27|北京 | 查看全部 阅读模式
动磁光电反馈高速扫描振镜高,适合从2mm光斑到100mm以上的光斑,以及新一代的全数字扫描系统。
The 6200H Series of closed loop galvanometer based optical scanners combines
our new moving magnet actuator technology with our innovative patented advanced optical position detector design.This combination offers the highest torque per watt and closed loop bandwidths, resulting in the highest positioning speed, precision and reliability available in any compact closed loop galvanometer in today's market.

具体资料见附件。

6200H-Fam-Data Sheet.pdf (172.51 KB, 下载次数: 16)

有需要和我联系。

Justing Bai(白建博)  Sales Specialist
A & P Instrument Co., Ltd. - Beijing Office
Mob:+8613488699569
Tel:+8610-62074835-212
Fax:+8610-62077434
Email: justing.bai@anpico.com      
Website: www.anpico.com

回复|共 6 个

Justing 楼主Lv.8 发表于 2010-7-2 10:42:34|北京 | 查看全部
打标应该用很多振镜吧,CTI是最好的了。
Justing 楼主Lv.8 发表于 2010-7-13 16:37:42|北京 | 查看全部
GSI和CTI合并了,振镜方面产品都归在CTI旗下。

详见:http://www.camtech.com/
czc568 Lv.2 发表于 2010-9-11 00:10:09|广东 | 查看全部
看看先,谢谢!能否提供一下振镜的控制方式呢?
zhouytang Lv.5 发表于 2010-11-25 17:57:43|浙江 | 查看全部
振镜的控制方式?
Justing 楼主Lv.8 发表于 2010-12-1 16:42:53|北京 | 查看全部
你指信号的话,通过数据采集卡把你的要求转变为电压信号,
单指振镜的话,通过其控制板来驱动。
laser10001 Lv.6 发表于 2011-3-10 19:25:19|浙江 | 查看全部
CTI6870的工作电压是多少?

回复

您需要登录后才可以回帖 登录 | 注册

本版积分规则

投诉/建议联系

admin@discuz.vip

未经授权禁止转载,复制和建立镜像,
如有违反,追究法律责任
  • 关注公众号
  • 添加微信客服
Copyright © 2026 光电工程师社区 版权所有 All Rights Reserved. Powered by Discuz! X5.0 Licensed 鄂ICP备17021725号-1
关灯 在本版发帖
扫一扫添加微信客服
返回顶部
快速回复 返回顶部 返回列表